Check the brake fluid level and adjust if necessary.Turn off the device to replace the brake fluid.Open and close the purge valve until the brake fluid flows without bubbles and impurities.Some purge computers include a vacuum unit to balance the fluid level during the process. Remove the cover and fasten the hose to a container suitable for brake fluid and purge valve.Fix the drain equipment into the tank of this system and connect it.On the other hand, in order to clean the coupling using special equipment for this purpose, as a rule, the following actions are performed: Check clutch drive and system for leaks.
In addition, it may result in injury from contact with skin and eyes, therefore it is important to have appropriate protective equipment).
In a hydraulic system, brake fluid flows in a closed circuit and the presence of air bubbles in it not only implies a change during operation, but can also lead to malfunctions in other parts that are interconnected with it.Īs a rule, to clean the coupling manually, the following steps are followed:
Why is it worth pumping the clutch? How to do it?Ĭlutch bleeding is an important task in a car service where a hydraulic system is used. This clutch is rarely used in conventional cars because of its high cost, but can more often be used in heavy industrial equipment. This is another type of clutch that allows you to transfer power from the engine to the gearbox, due to the effect of the electromagnetic field. This type of clutch is usually installed in cars with an automatic transmission with a torque converter and in trucks. In this type of clutch, rotational motion from the engine drives the pump, and the fluid of the hydraulic pump circulates through the rotating turbines mounted on the gearbox. This disk is coupled to the engine flywheel due to the plate and oppressors, and the action of the springs (via cable) or using a hydraulic actuator. In this class, the clutch, steering wheel, the engine is attached and separated from the gearbox due to the clutch disc and transmission shaft.
Although friction clutches can be classified according to various factors, the most common way to do this is depending on the type of control: